ME0D0E1NDB70

Yes

To enable breakout interfaces, run the port split command to complete breakout configuration.

All the four 10GE interfaces split from one interface must work in the same LAN or WAN mode(The 10G interfaces working in WAN mode can function only as master interfaces).The default transmission rate of an interface on the subcard is 100 Gbit/s. When the transmission rate of an interface on the used optical module does not match the default rate, for example, when a 40G optical module is used, run the port split command to enable the interface breakout function.

Half-width. When the 02312NCX optical module is installed on the board, the long-term operating temperature of the optical module ranges from 0°C (32°F) to 45°C (113°F).

100Gbps QSFP28 optical module

40Gbps QSFP+ optical module